Editing Step 18 —
Elbow Tail Housing - 1

Step Type:

Drag to rearrange

Notice that looking at it from the side, one end of the Machined Aluminum Pipe has 2 holes and the other end has 1 holes, the end with the 2 holes is the Elbow Tail End

Insert the Sixi Sleeve on the Aluminum Pipe between two alignment holes

Insert and align the 1-hole end of the Pipe into the Ulna Gearbox Housing and secure it in place with M3x10mm Screws

Screws on both side

Your contributions are licensed under the open source Creative Commons license.