find the 3 wire JST cables that have three colors, typically red/blue/black.
Cut the wire 43cm from one end. The second piece should be approximately 58cm. strip 5mm from the newly-cut end of both.
if you are doing multiple machines, cut them all into two piles, then strip them, then solder them. fewer task changes is faster production.
the short wire is for the left side of the machine. the long wire is for the right.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.