Editing Step 18 —
Picasso Wrist Magnet Holder

Step Type:

Drag to rearrange

Insert the the cable end of the Brass Tube {Sensor Shaft} through the Assembled Side Bevel Gear

Insert Picasso Magnet Holder on the Brass Tube and align the set screw holes

When aligned properly, "Half Moon Cut" on the Brass Tube should line up with the opening on the Magnet Holder

Secure the Magnet Holder using M3 Set Screw

Push the Magnet Holder into the 6701 Bearing that's in the Pulley Gear

Your contributions are licensed under the open source Creative Commons license.