Help
Event | Count | Delta |
---|---|---|
Admin approved your guide | 30 | 5496 |
Someone completed your guide | 16 | 470 |
Admin approved your wiki | 4 | 200 |
Categorization accepted | 7 | 7 |
Install the firmware as instructed and the mintemp message will be gone.
I added a new picture with new colors. Is that better?
Nearly any NEMA17 will work. https://www.omc-stepperonline.com/nema-1...
NEMA17 is 42mm on each side. Length of the motor depends on the torque.
Yes! 3mm or 1/8”
Clarified & correted these instructions. Thank you!
libraries are downloaded through Sketch > Include Library > Manage Libraries. Which libraries are you missing?
Were the pockets completely cleaned of support material?