Skip to main content
/

Site Navigation

Your Account

Choose Language

Help

Step Type:

Drag to rearrange

Pay special attention to the order of the colors when soldering.

Using the iron to melt the solder on both the switch leg and the wire, fuse them together. remove the iron and wait a moment for the solder to cool. This is an example of a good solder.

This is an example of BAD solder. Note the loose wires that were not twisted or pre tinned. This will break or short circuit very quickly.

Once the wires are soldered, use a zip tie to attach each switch to the mounting plates. Trim the excess zip tie.

The switches MUST be mirror images of each other!

Your contributions are licensed under the open source Creative Commons license.