Step Type:

Drag to rearrange

For our new alignment method, Eccentricity is aligned with the T and B label of the Rotors.

Notice how the Top Rotor is sticking out yet the Bottom Rotor is not.

While keeping the Eccentric Shaft and Top Rotor in a fixed position, rotate the Bottom Rotor to a point where you can see the Bottom Alignment Hole

Rotate a little more so that the Top and Bottom Alignment Holes are aligned to each other.

A pin can be fit right through the 2 alignment holes if done correctly

When this is done, you will be able to see that the sharpie marks made from Step 5 aligns vertically too

Your contributions are licensed under the open source Creative Commons license.