Option 1: Using the extra triangle and the m3 screws, clamp the corner mounts to the board. We do not have a satisfactory way to mount the electronics yet.
Option 2: Screw the components to the board.
It is easiest if the center of each motor shaft is right at each corner of the board.
Make sure your board is off the floor to leave room for the counterweights!
Proceed to Counterweight & belt setup
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.