Insert the suction cups: 3 in each triangular corner, and 2 in each of the control boards.
wet the suction cups before pressing the components to the top of the glass. Try to get the motors at the same height and as level as possible. The electronics must go between the motors.
arrange the cables so that no cables hang down in the drawing area of the machine. The drawing area is the area under and between the two motors. Some droop at the top is OK.
Proceed to Counterweight & belt setup
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.