Editing Step 6 —
Eccentric Input Shaft - 1

Step Type:

Drag to rearrange

Put the 6702 Bearing on the Thicker Concentric piece of the Shaft Holder

Notice that the thinner piece of the Shaft Holder has 2 sides, one where screw lined up to the center of the face and other which is eccentric

Clamp Shaft Holder Cam pieces using M3x30mm Screws

Thicker piece is the Screw Head side,

Only screw in until the tip of the screw is flushed with the face of the thinner piece

Your contributions are licensed under the open source Creative Commons license.