Sixi 2 Robot Arm
View
Options
History
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
Introduction
Details
Guide Steps
Review
Quiz
Clamp 6702 Bearing with Shaft Holder Cams using M3x30mm Screws
Thicker piece is the Screw Head side,
Only screw in until the tip of the screw is flushed with the face of the thinner piece
Insert both Rotors on the Eccentric Cam
The Screw Head side of each rotor is facing away from each other
Align the Eccentric Cam and Shaft Holder Cams and partially screw in the M3x30mm Screws.
Check that the T Rotor is facing the Shaft Holder Cam
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.