Changes to [old] Makelangelo 3.3 setup Introduction

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged
Category
User Guides
Type
how-to
Title
Makelangelo 3.2 wall setup
Introduction
This guide will show you the steps to get your Makelangelo 3.2 robot ready to begin a drawing. It does not include the software or firmware readiness, which is covered in other documents.
Time Required Min
No estimate
Time Required Max
No estimate
Difficulty
Moderate
Author
Dan Royer
Public
No
Summary
Getting your Makelangelo 3.2 mechanically ready to begin drawing.
Ogdc Enabled
inherit

Flags

  • In Progress added.

Steps

Step #: 1
Before
After
stepid 64 stepid 64