Changes to Step #16
Step Lines
| + | [title] Attach the LCD panel |
|---|---|
| + | [* 2] Insert three M3x35 screws and put one 25mm spacer on each. |
| + | [* 5] Note the ribbon cables go to their corresponding color. Note the red edge and which way it is positioned. |
| + | [* 6] Note the servo wire coming out the top. |
| + | [* 3] Place the LCD onto the screws and secure in place with three M3 nuts. |
| + | [* 10] Congratulations! You are done with assembly of the motor mounts and the control board. The Makelangelo pen holder and the firmware uploading are handled in other tutorials. Give yourself a high-five! |
Image 1
No previous image
Added
Image 2
No previous image
Added