Changes to Step #11
Step Lines
| + | [title] power connection |
|---|---|
| + | [* 1] Solder the black wire to the north pole of the power connector following the same techniques used for the switches. |
| + | [* 2] Solder the red wire to the west pole of the power connector following the same techniques used for the switches. |
| + | [* 1] Leave the east pole unconnected. There is no south pole here. |
| + | [* 4] Press the socket into the mounting block. Note that one side of the block is slightly larger. The smaller side should be towards the wires. |
| + | [* 5] Screw the mounting block to the side of the control panel with two M3x10 screws. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added