Changes to Step #7
Step Lines
| + | [title] Assemble two motor mounts (continued) |
|---|---|
| + | [* 2] Carefully turn the assembly over and then tighten the four screws into the motor. |
| + | [* 4] slide a GT2-20 pulley onto the motor shaft until the thin end is flush with the inside of the back plate. |
| + | [* 3] Use an alan key to tighten the set screw against the flat side of the motor shaft. |
| + | [* 5] Tighten the second set screw for good measure. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added