Changes to Step #6
Step Lines
| + | [title] Assemble two motor mounts |
|---|---|
| + | [* 2] insert four M3x35 screws into the holes, flip the board over, and then put one 25mm spacer on each screw. This picture shows only three spacers on four screws. |
| + | [* 8] Mount the switch plate on top of the screws. The cables should come out along thie purple arrow, NOT go between the screws as this picture shows. |
| + | [* 5] Remember the mirror images? If the diagonal part of the wood is on the left... |
| + | [* 3] ...then the switch must be on the right. On the other motor mount we will do things mirrored. |
| + | [* 6] Put the motor on top of the switch plate. Not the direction of the wires coming out of the motor should be on the same side as the diagonal part. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added