Changes to Step #2
Step Lines
| [title] Strip the wire ends | |
| [* 2] Using a wire stripper, cut the end of the wire. Get as close to the connector as possible. | |
| [* 4] Put the cut wires into the wire stripper and squeeze to remove the last 3-4mm of the insulating jacket. Done correctly you can strip all three in one movement. | |
| [* 10] Turn the stripper over and tap it on a hard surface to knock the jacket pieces out of the stripping mechanism. | |
| [* 5] Your stripped wires should look like this. | |
| + | [* 1] Repeat this step for the second wire. |
| + | [* 9] Only strip one end of each wire! |