| + | [title] Run the robot connected |
|---|
| + | [* 1] Plug the a USB cable from the robot into your PC running Makelangelo Software. |
|---|
| + | [* 1] Click ''Connect'' and choose one of the USB ports. After a few seconds the buttons under connect should turn from grey to black. |
|---|
| + | [* 1] If there are no ports, refer to the ''Updating Makelangelo firmware'' guide steps for updating the USB driver. |
|---|
| + | [* 1] Click ''find home'', then click ''Start''. Follow the prompts on the LCD panel. |
|---|
| + | [* 1] Don't forget to home the robot before starting your drawing! |
|---|