Changes to Step #6

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

[title] Cut wires for limit switches
-[* 1] find the 3 wire JST cables that have three colors, typically red/blue/black.
-[* 1] Cut the wire 43cm from one end. The second piece should be approximately 58cm. strip 5mm from the newly-cut end of both.
+[* 1] Find the 1m 3-wire dupont cables that have three colors, typically red/blue/black.
+[* 1] Cut the wire 43cm from one end. The second piece should be approximately 58cm. Strip the newly cut ends.
[* 1] if you are doing multiple machines, cut them all into two piles, then strip them, then solder them. fewer task changes is faster production.
[* 1] the short wire is for the left side of the machine. the long wire is for the right.