Changes to Step #9
Step Lines
| [title] Adjust RUMBA before install | |
| + | [* 9] Make sure power is OFF during this step. Permanent damage to the electronics could result if power is on. |
| [* 2] Using a tool with a fine tip, press the dip switches from north (default) to south. The dip switches set the microstepping. The firmware expects all switches to be down for 1/16th microstepping. | |
| [* 3] there are three pins marked ***USB/Stand-alone***. By default new boards have a jumper connecting the south two pins, USB position. The jumper must be moved to the Stand-alone position connecting the north two pins. Note the empty south pin. |