Changes to Step #16
Step Lines
| [title] Attach the power connection | |
| [* 1] Take a pair of black and red wires 43 cm in length | |
| [* 1] Solder the black wire to the north pole and the red wire to the west of the power connector following the same techniques used for the switches. | |
| [* 4] Slide the 12v power plug into holder. Note that once side of the holder is slightly larger than the other. It fits better the correct way around. | |
| [* 5] Thread two M3x10 screws into holder through the two extra holes beside the right-hand motor | |
| - | [* 9] Tighten |
| + | [* 9] Tighten until the plastic meets the wood and the screw is flush with the wood. Do not overtighten or the screw will strip the plastic and fall out. |