Changes to Step #11

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

[title] Attaching Rumba board
-[* 3] Place wires from right hand limit switch in between the screws already in the board
-[* 5] Thread and tighten 4 M3 hexnut nylocks onto the four screw poking through
+[* 3] Place wires from right hand limit switch in between the screws for holding the board
+[* 5] Put the RUMBA board on the screws and thread and tighten 4 M3 hexnut nylocks onto the four screws poking through
[* 4] Plug the limit switches into indicated pins. the left switch connects to X- with the green wire on the right.
[* 2] The right switch connects to X+ with the green wire on the right.