Changes to Step #11

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

[title] Attaching Rumba board
[* 3] Place wires from right hand limit switch in between the screws already in the board
[* 5] Thread and tighten 4 M3 hexnut nylocks onto the four screw poking through
-[* 4] Plug the limit switches into indicated pins. the left switch connects to X+ with the green wire on the right.
-[* 2] The right switch connects to X- with the green wire on the right.
+[* 4] Plug the limit switches into indicated pins. the left switch connects to X- with the green wire on the right.
+[* 2] The right switch connects to X+ with the green wire on the right.