Changes to Step #19

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

[title] Shoulder Gearbox Sensor - Preparation
-[* 2] Also prepare the Sensor Cable for Shoulder [numbered 1]
+[* 2] Also ***prepare the Sensor Cable for Shoulder*** [365mm 6-pin Brown to Blue Ribbon Cable - ++#1 Sensor Cable++]
[* 9] There is a separate assembly guide for all sensor cable which shows the length of each as well.
-[* 1] Connect the Cable to the AS5147 Sensor as shown in the second picture
-[* 3] Insert the Neodymium magnet in the Shoulder Magnet Holder
+[* 1] Connect the ++Cable++ to the ***AS5147 Sensor ***as shown in the second picture
+[* 3] Insert the ***Neodymium Magnet ***in the ++Shoulder Magnet Holder++