Changes to Step #14

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

+[title] Shoulder Gearbox Bottom - 1
+[* 2] Align the Bearing Insert of the Gearbox Bottom Sensor Side Piece to the Shaft Holder Cam Bearing of the Input Shaft
+[* 3] Insert M3x45mm Screws all the way through
+ [* 9] If Screws aren't going in correctly, you will have to re do the steps, go to ***aligning the Rotor Step***
+[* 5] Keep the Gearbox laying on its side for easier assembly