Changes to Step #12
Step Lines
| [title] Shoulder Gearbox Housing - Housing Clamp | |
| [* 2] Once the Rotor is Properly aligned, all 12 inner holes will have the same space between them when looking directly above it | |
| [* 9] The Angle of the picture taken of the aligned Rotors are a bit off. | |
| [* 3] Carefully insert the Rotor while maintaining this position on the Housing with the pins. | |
| [* 9] Make sure the ***Motor Shaft Adapter side of the shaft is Pointing out*** | |
| + | [* 1] Press the second half of the housing into place. |
| + | [* 10] Verify that you can manually turn the eccentric shaft in the center and that the rotors smoothly turn inside the housing. Tight printing and misaligned rotors can cause the gearbox to jam. |
| [* 1] Clamp the other half of the Housing using M3x25mm Screws and Nylock Nuts | |
| [* 5] Secure tightly using the 5.5mm Socket Driver to hold the Nuts. |