| + | [title] Shoulder Gearbox Housing - Housing Clamp |
|---|
| + | [* 2] Once the Rotor is Properly aligned, all 12 inner holes will have the same space between them when looking directly above it |
|---|
| + | [* 9] The Angle of the picture taken of the aligned Rotors are a bit off. |
|---|
| + | [* 3] Carefully insert the Rotor while maintaining this position on the Housing with the pins. |
|---|
| + | [* 9] Make sure the Shaft Holder Cam side of the shaft is going in first |
|---|
| + | [* 1] Clamp the other half of the Housing using M3x25mm Screws and Nylock Nuts |
|---|
| + | [* 5] Secure tightly using the 5.5mm Socket Driver to hold the Nuts. |
|---|