Changes to Step #6
Step Lines
| [title] Eccentric Input Shaft - 1 | |
| [* 1] Clamp 6702 Bearing with Shaft Holder Cams pieces using M3x30mm Screws | |
| [* 2] Thicker piece is the Screw Head side, | |
| [* 3] Only screw in until the tip of the screw is flushed with the face of the thinner piece | |
| [* 4] Insert Both Rotors on the Eccentric Cam | |
| - | [* 9] The Screw Head side of each rotor is facing away from each other |
| - | [* 5] Align the Eccentric Cam and Shaft Holder Cams and partially screw in the M3x30mm Screws. |
| - | [* 7] Check that the T Rotor is facing the Shaft Holder Cam |