Changes to Step #21

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

[title] Picasso Box Clamp - Side Bevel Gear
-[* 1] Insert*** M3 Nuts ***on the inside faces of both Top and Bottom ***Picasso Box Parts***
[* 1] Align the ++6706 Bearing closer to Bevel Gear++ to the Picasso Bearing insert space of ***++6Aa ++Picasso***
-[* 1] Tighten the ***M3 Set Screw*** on the 6Aa part and Brass Tube while the Sensor chip is face the smaller bearing insert space
+ [* 9] Hand Sensor Chip should be facing the Hand Gearbox
+[* 2] Secure the Sensor Shaft to the 6Aa Box using ***M3 Set Screw***