Changes to Step #21

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

[title] Picasso Box Clamp - Side Bevel Gear
-[* 1] Insert Screws on the inside faces of both Picasso Parts
-[* 1] Align the Bearing closer to Bevel Gear to the Picasso Bearing insert space of 6Aa Picasso
-[* 1] Tighten the Set Screw on the 6Aa part and Brass Tube while the Sensor chip is face the smaller bearing insert space
+[* 1] Insert*** M3 Nuts ***on the inside faces of both Top and Bottom ***Picasso Box Parts***
+[* 1] Align the ++6706 Bearing closer to Bevel Gear++ to the Picasso Bearing insert space of ***++6Aa ++Picasso***
+[* 1] Tighten the ***M3 Set Screw*** on the 6Aa part and Brass Tube while the Sensor chip is face the smaller bearing insert space