Changes to Step #18

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

[title] Picasso Wrist Magnet Holder
[* 1] Insert the the ***++cable end++ of the Brass Tube*** {Sensor Shaft} through the ''++Assembled Side Bevel Gear++''
- [* 9] Half Moon Slot side is where the cable comes out. This also shows that Set Screw Holes on the Magnet Holder and the Brass Tube are aligned
-[* 1] Insert ***Picasso Magnet Holder*** on the Brass Tube and ''++align the set screw holes++''
+[* 3] Insert ***Picasso Magnet Holder*** on the Brass Tube and ''++align the set screw holes++''
+ [* 9] When aligned properly, ***"Half Moon Cut" on the Brass Tube*** should line up with the opening on the ***Magnet Holder***
+[* 5] ++Push the ***Magnet Holder*** into the ++6701 Bearing++ that's in the ***Pulley Gear***++