Changes to Step #18

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

[title] Picasso Wrist Magnet Holder
-[* 1] Insert the the cable end of the Brass Tube through the assembled Side Bevel Gear and to the Magnet Holder with the magnet already in [PIC REQUIRED]
+[* 1] Insert the the ***++cable end++ of the Brass Tube*** {Sensor Shaft} through the ''++Assembled Side Bevel Gear++''
[* 9] Half Moon Slot side is where the cable comes out. This also shows that Set Screw Holes on the Magnet Holder and the Brass Tube are aligned
-[* 1] Make sure that Set Screw Holes are aligned and screw in the Set Screw
-[* 1] Push the Magnet Holder to the 6701 Bearing on the Pulley Gear
+[* 1] Insert ***Picasso Magnet Holder*** on the Brass Tube and ''++align the set screw holes++''