Changes to Step #18

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

+[title] Sensor Shaft - Picasso Magnet Holder
+[* 1] Insert the the cable end of the Brass Tube through the assembled Side Bevel Gear and to the Magnet Holder with the magnet already in [PIC REQUIRED]
+ [* 9] Half Moon Slot side is where the cable comes out. This also shows that Set Screw Holes on the Magnet Holder and the Brass Tube are aligned
+[* 1] Make sure that Set Screw Holes are aligned and screw in the Set Screw
+[* 1] Push the Magnet Holder to the 6701 Bearing on the Pulley Gear