Changes to Step #16

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

-[title] Sensor Shaft - Hand Sensor Cable
-[* 1] Connect the Jumper Wires EXACTLY shown in the picture [PIC REQUIRED]
+[title] Hand Sensor Holder - Sensor Cable
+[* 1] Connect the Cable to the ***AS5147 Sensor*** as shown in the picture
[* 9] COLOR CODE MATTERS!!
-[* 1] One wire at a time, feed the jumper wires through the brass tube [PIC REQUIRED]
-[* 1] Make sure the Jumper Wires comes out of the brass tube as far as it can. NO LOSE Cables [PIC REQUIRED]
+[* 1] One wire at a time, feed the ***jumper wires*** through the ***Brass Tube***
+[* 1] Make sure the ***Jumper Wires*** comes out of the ***Brass Tube*** as far as it can. NO LOOSE Cables