Changes to Step #16

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

+[title] Sensor Shaft - Hand Sensor Cable
+[* 1] Connect the Jumper Wires EXACTLY shown in the picture [PIC REQUIRED]
+ [* 9] COLOR CODE MATTERS!!
+[* 1] One wire at a time, feed the jumper wires through the brass tube [PIC REQUIRED]
+[* 1] Make sure the Jumper Wires comes out of the brass tube as far as it can. NO LOSE Cables [PIC REQUIRED]