Changes to Step #15

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

-[title] Sensor Shaft - Hand Sensor Holder
-[* 1] Mount the Sensors on the Sensor Holder using the M2 screws
-[* 1] Insert the brass tube through the sensor holder [PIC REQUIRED]
+[title] Hand Sensor Holder - Sensor Shaft
+[* 2] Mount the ***AS5147 Sensor*** on the ''++Sensor Holder++'' using the ***M2 Screws***
+[* 3] Insert the ***Brass Tube*** through the ***Sensor Holder***
[* 9] ORIENTATION of the Brass Tube matters!!!!!!! Follow exactly to the picture
-[* 1] Tighten the Set Screw just enough to secure the sensor holder in the correct position of the brass tube [PIC REQUIRED]
+[* 1] Use ***M3 Set Screw*** to secure the ''++Sensor Holder++'' to the ***Brass Tube***