Changes to Step #14

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

[title] Sensor Shaft - Parts
[* 10] ***Prepare the following parts***
[* 1] [3D] - 6Ae Hand Sensor Holder
[* 2] AS5147 Sensor {straight header on the label side}
- [* 3] 3/8'x76.5mm Machined Brass Tube
- [* 5] 210mm F/F 6pin Jumper Wire (Brown to Blue) still attached to each other)
+ [* 3] Brass Tube [3/8'x76.5mm]
+ [* 5] 6-pin Ribbon Cable F/F - Brown to Blue {sensor 5 Hand Ext.} - [210mm]
[* 6] M3x4mm Set Screws (x1)
[* 7] M2x6mm Screws (x4)