Changes to Step #14

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

-[title] Hand Sensor Holder - Parts
+[title] Sensor Shaft - Parts
[* 10] ***Prepare the following parts***
[* 1] [3D] - 6Ae Hand Sensor Holder
[* 2] [3D] - 6Ca Picasso Magnet Holder
[* 3] AS5147 Sensor {straight header on the label side}
[* 5] 3/8'x76.5mm Machined Brass Tube
[* 6] 210mm F/F 6pin Jumper Wire (Brown to Blue) still attached to each other)
[* 7] M3x4mm Set Screws (x1)
[* 8] M2x6mm Screws (x4)