Changes to Step #14

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

+[title] Sensor Shaft - Hand Sensor Holder Parts
+[* 10] ***Prepare the following parts***
+ [* 1] 6Ae - Hand Sensor Holder
+ [* 1] 6Ca - Picasso Magnet Holder
+ [* 1] 3/8'x76.5mm Machined Brass Tube
+ [* 1] 210mm F/F 6pin Jumper Wire (Grey-to-Green still attached to each other)
+ [* 1] M3x4mm Set Screws (x1)
+ [* 1] M2x6mm Screws (x4)