| - | [* 9] Inserting the Rotors in the gearbox housing requires correct alignment of the rotors. ***Look at the pictures carefully*** |
|---|
| - | [* 2] Align the ***"T" labels*** on the top rotor and the housing and insert only the Top Rotor [NEW PIC REQUIRED] |
|---|
| - | [* 5] Align the ***"B" labels*** on the bottom rotor and the housing and insert the Bottom Rotor [NEW PIC REQUIRED] |
|---|
| - | [* 9] CHECK! That all 8 holes made by the 2 rotors are identical sizes |
|---|
| - | [* 1] Insert the assembled output disk [NEW PIC REQUIRED] |
|---|
| + | [* 9] ***Rotor Alignment*** is very IMPORTANT! Follow the pictures carefully! |
|---|
| + | [* 2] Make a ++''sharpie marks on the side of the Rotors''++ where it lines up with ***"T" and "B" on the rotors*** |
|---|
| + | [* 3] Align the ***Side Mark of "T" Rotor*** to the ++"T" on the Housing++, and only insert Top Rotor into the housing. |
|---|
| + | [* 5] Align the ***Side Mark of "B" Rotor*** to the ++"B" on the Housing++, and insert the Bottom Rotor |
|---|