Changes to Step #7

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

[title] Hand Gearbox - Output Disks
[* 10] ***Prepare the following components:***
- [* 2] [3D] - 6D Output Disk Components
+ [* 2] [3D] - 6Da Hand GB Output Disks
[* 1] ***Thicker Output Disk*** is considered ++"Top"++
- [* 3] 30x37x4mm 6706 Bearing (x1)
- [* 5] M3 x 20mm Screws (x8)
+ [* 3] 6706 Bearing [30x37x4mm] (x1)
+ [* 5] M3x20mm Screws (x8)
[* 6] M3 Hex Nuts (x11)
[* 7] Insert ***M3 Hex Nuts*** in the nut inserts of ''++Both Output Disks++''
[* 8] Align the ++***3 middle holes*** of Top and Bottom Disks.++ Clamp the ***6706 bearing*** with the Output Disks using ***M3x20mm Screws***