2. Picasso Box Assembly Step #6 History - mcr

Changes to Step #6

Edit by Dan Royer — Jan 22, 2020

Edit approved by Dan Royer

: Before
: After
: Unchanged

Step Lines

	[title] Hand Gearbox - Input Shaft & Rotor
-	[* 1] Insert the thicker eccentric cam on the brass tube and *align the set screw holes* and insert the set screws [PIC REQUIRED]
-	[* 9] Make sure the Set Screw screws in just enough to put the bearing in, DON'T SCREW ANY MORE THAN THAT!
-	[* 7] Place the *"B" Rotor* onto the eccentric cam [PIC REQUIRED]
+	[* 2] Align the *Thick Eccentric Cam* {Bottom} to the next Set Screw Hole
+	[* 3] Use the *M3 Set Screw *to secure its location
+	[* 9] Make sure the *Set Screw* ''++goes in just enough for the bearing to slide over++'' NO MORE!!
+	[* 5] Place the *"B" Rotor* onto the eccentric cam with the label facing the *Bevel Gear*
	[* 9] Notice that the Rotor has a side that catches the outer part of the bearing. Make sure this side is facing up (away from the bevel gear)
-	[* 4] Repeat with the ~~second (thinner) eccentric cam~~ and *"T" Rotor* ~~[PIC REQUIRED]~~
+	[* 6] Repeat with the *Thin Eccentric Cam* {Top} and *"T" Rotor*