Changes to Step #4

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

-[title] Hand Gearbox - Input Shaft
+[title] Hand Gearbox - Input Shaft 2
[* 1] Insert ***6701 Bearing*** in the ***Bevel Gear***
[* 1] Align the ***Brass Tube Hole ***to the ''Bevel Gear Set Screw Hole''
[* 3] Secure the Gear using ***M3 Set Screw *** then slide the ***6701 Bearing***
[* 9] Make sure the ***''Set Screw goes in just enough''*** for the bearing to go on, ++NO MORE THAN THAT++