Skip to main content

Changes to Step #19

Edit by Dan Royer

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

[title] Arduino Installation - Motor Signal Cables
-[* 2] Start with Motor 0 signal cable to the Right most connector labelled "M0"
-[* 3] M0, M1 and M2 follows the same color pattern
- [* 10] from the right, Black, Red, Green, Blue
-[* 6] M3, M4, M5 follows a different color patter from M0-M2,
- [* 10] from the right, Red, Black, Green, Blue
+[* 2] Start with ***Motor 0 signal cable*** to the Right most connector labelled "M0"
+[* 3] ***M0, M1 and M2*** follows the same color pattern
+ [* 10] from the right, ++Black, Red, Green, Blue++
+[* 6] ***M3, M4, M5*** follows a ++different color pattern++ from M0-M2,
+ [* 10] from the right, ++Red, Black, Green, Blue++