Changes to Step #17

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

[title] Arduino Installation - Tray Preparation
-[* 2] Align the Holes on the Tray and the Arduino Mega
+[* 2] ++Align the Holes++ on the Tray and the Arduino Mega
[* 3] Use the ***M3x10mm Screws*** and ***M3 Nylock Nuts*** to secure the Arduino to the Tray
- [* 9] Make sure to tighten the screws just enough to hold them together, No more, since over-tightening the screws can damage the board.
+ [* 9] Make sure to ++tighten the screws just enough++ to hold them together, No more, since ***over-tightening the screws can damage the board***.