Changes to Step #17

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

[title] Arduino Installation - Tray Preparation
[* 2] Align the Holes on the Tray and the Arduino Mega
-[* 3] Use the M3x10mm Screws and M3 Nylock Nuts to secure the Arduino to the Tray
+[* 3] Use the ***M3x10mm Screws*** and ***M3 Nylock Nuts*** to secure the Arduino to the Tray
[* 9] Make sure to tighten the screws just enough to hold them together, No more, since over-tightening the screws can damage the board.