Changes to Step #16

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

[title] Arduino Installation - Standoff
[* 2] Insert ***M3 Hex Nuts*** in the side slot of the Arduino Standoff
[* 3] Partially screw in*** M3x16mm Screws *** for easier assembly
-[* 10] Secure the Standoff to the Case by tightening the Screws in place.
- [* 5] Notice the Orientation of the Standoff as well as the position of the cables relative to the pegs of the Standoff
+[* 10] Secure the ***Standoff to the Case*** by tightening the Screws in place.
+ [* 5] ++Notice the Orientation ++of the Standoff as well as the position of the cables relative to the pegs of the Standoff