Changes to Step #16

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

[title] Arduino Installation - Standoff
-[* 2] Insert M3 Hex Nuts in the side slot of the Arduino Standoff
-[* 3] Partially screw in M3x16mm Screws for easier assembly
+[* 2] Insert ***M3 Hex Nuts*** in the side slot of the Arduino Standoff
+[* 3] Partially screw in*** M3x16mm Screws *** for easier assembly
[* 10] Secure the Standoff to the Case by tightening the Screws in place.
[* 5] Notice the Orientation of the Standoff as well as the position of the cables relative to the pegs of the Standoff