Changes to Step #11

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

[title] Arduino Mega Shield Introduction
[* 10] ++These custom Arduino Mega Shield contains following components:++
- [* 2] 8-pin 2.54mm pitch Screw Terminal (x3)
- [* 3] 4-pin 2.54mm pitch Screw Terminal (x1)
- [* 4] 2-pin 3.5mm pitch Screw Terminal (x1)
- [* 5] 2N2222A NPN Transistors (x6)
- [* 6] MP1584EN Voltage Regulator (x2)
- [* 7] 37-pin Right Angle D-Sub Wall Mount Connector
+ [* 2] Screw Terminal 8p - 2.54mm (x3)
+ [* 3] Screw Terminal 4p - 2.54mm (x1)
+ [* 4] Screw Terminal 2p - 3.5mm (x1)
+ [* 5] NPN Transistor 2N2222A (x6-9)
+ [* 6] Voltage Regulator MP1584EN (x2)
+ [* 7] D-SUB F-Conn right-angle 37p
[* 9] Before we connect this to the Arduino Mega, the ***Voltages in the MP1584EN must be adjusted.***