Changes to Step #11

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

[title] Arduino Mega Shield Introduction
-[* 10] These custom Arduino Mega Shield contains following components:
+[* 10] ++These custom Arduino Mega Shield contains following components:++
[* 2] 8-pin 2.54mm pitch Screw Terminal (x3)
[* 3] 4-pin 2.54mm pitch Screw Terminal (x1)
[* 4] 2-pin 3.5mm pitch Screw Terminal (x1)
[* 5] 2N2222A NPN Transistors (x6)
[* 6] MP1584EN Voltage Regulator (x2)
[* 7] 37-pin Right Angle D-Sub Wall Mount Connector
-[* 9] Before we connect this to the Arduino Mega, the Voltages in the MP1584EN must be adjusted.
+[* 9] Before we connect this to the Arduino Mega, the ***Voltages in the MP1584EN must be adjusted.***