Changes to Step #11

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

[title] Arduino Mega Shield Introduction
[* 10] ++These custom Arduino Mega Shield contains following components:++
[* 2] Screw Terminal 8p - 2.54mm (x3)
[* 3] Screw Terminal 4p - 2.54mm (x1)
[* 4] Screw Terminal 2p - 3.5mm (x1)
[* 5] NPN Transistor 2N2222A (x6-9)
[* 6] Voltage Regulator MP1584EN (x2)
[* 7] D-SUB F-Conn right-angle 37p
-[* 9] Before we connect this to the Arduino Mega, the ***Voltages in the MP1584EN must be adjusted.***
+[* 9] The voltages in the MP1584EN ***must*** be adjusted ''before'' we connect this to the Arduino Mega. Incorrect voltage could damage the electronics.